Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Rulebase Configuration Mode Commands
websocket flow-detection ▀
Command Line Interface Reference, StarOS Release 16 ▄
773
websocket flow-detection
This command allows you to enable or disable websocket flow detection at rulebase level.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
[ no ] websocket flow-detection [ protocol1 | protocol2 | protocol3 | ...]
no
Disables the websocket flow detection.
[ protocol 1 | protocol2 | protocol3 | ... ]
Specifies protocol for detection.
If both protocol1 and protocol2 are specified, then specifies protocol detection of both protocols.
If both protocol1 and protocol2 are specified, then specifies protocol detection of both protocols.
Usage
Use this command to disable or enable websocket flow detection identification of protocols.
Important:
Currently, websocket is only using HTTP protocol as a transport layer, so the CLI will have only http
as option.
Example
The following command disables websocket flow detection identification of protocols:
no websocket flow-detection [proto1 | proto2 | proto3 ]