Cisco Cisco Packet Data Interworking Function (PDIF)
SaMOG Service Configuration Mode Commands
▀ associate
▄ Command Line Interface Reference, StarOS Release 16
8138
associate
SaMOG associates another service to this SAMOG service.
Product
SaMOG
Mode
Exec > Global Configuration > Context Configuration > SAMOG Service Configuration
configure > context context_name > samog-service samog_service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-samog-service)#
Syntax
associate { cgw-service cgw_service_name | dhcp-service dhcp_service_name | mrme-service
mrme_service_name | subscriber-map subscriber_map_name }
mrme_service_name | subscriber-map subscriber_map_name }
no associate { cgw-service | dhcp-service | dhcpv6-service | mrme-service | subscriber-
map }
map }
no
Disables the association of the service with the SaMOG service.
The
The
no associate dhcp-service
command does not disassociate existing sessions, and only new
sessions will not be established. Existing sessions continue to use the DHCPv4 service to which it was bound
during session establishment.
during session establishment.
cgw-service
cgw_service_name
The CGW service should be configured before associating the same with SaMOG service.
cgw_service_name
must be an alphanumeric string between 1 and 63 characters.
dhcp-service dhcp_service_name
Specifies the DHCPv4 service to associate with the SaMOG service. DHCPv4 is optional while starting an
SaMOG service.
SaMOG service.
dhcp_service_name
must be an alphanumeric string from 1 through 63.
While the association of the DHCPv4 service with the SaMOG service is optional, DHCPv4 service must be
associated with the SaMOG service for the SaMOG Ethernet over GRE (EoGRE) feature to function. If no
DHCPv4 service is configured and associated, and at least one EoGRE access type Radius client exist, the
output of the
associated with the SaMOG service for the SaMOG Ethernet over GRE (EoGRE) feature to function. If no
DHCPv4 service is configured and associated, and at least one EoGRE access type Radius client exist, the
output of the
show configuration errors
command will display a warning under the SaMOG service
system errors section.
Important:
The associated DHCPv4 service must not be used for any service other than SaMOG, as packets are
always forwarded over the EoGRE tunnel only.
mrme-service mrme_service_name
The MRME service should be configured before associating the same with SaMOG service.
mrme_service_name
must be an alphanumeric string from 1 through 63 characters.