Cisco Cisco Packet Data Interworking Function (PDIF)
Service Redundancy Protocol Configuration Mode Commands
▀ monitor hsrp
▄ Command Line Interface Reference, StarOS Release 16
8212
monitor hsrp
Enables monitoring of the Hot Standby Router Protocol (HSRP) connection between the ASR 9000 Route Switch
Processor (RSP) and the StarOS Security Gateway (SecGW) running in a virtual machine on the Virtualized Services
Module. HSRP is employed in high availability (HA) SecGW configurations. (ASR 9000 VSM only)
Processor (RSP) and the StarOS Security Gateway (SecGW) running in a virtual machine on the Virtualized Services
Module. HSRP is employed in high availability (HA) SecGW configurations. (ASR 9000 VSM only)
Product
SecGW
Privilege
System Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Service Redundancy Protocol Configuration
configure > context context_name > service-redundancy-protocol
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-srp)#
Syntax
monitor hsrp interface if_name afi-type type hsrp-group hsrp_group
no monitor hsrp
no
Turns off the monitoring.
interface
if_name
Specifies the name of an existing RSP interface as an alphanumeric string of 1 through 63 characters.
afi-type
type
Specifies the RSP name of an existing Address Family Type (IPv4 or IPv6) as an alphanumeric string of 4
through 15 characters.
through 15 characters.
hsrp-group
hsrp_group
Specifies the RSP name of an existing HSRP Group ID as an integer from 0 through 4095.
Usage
Use this command to enable monitoring of the HSRP connection between the ASR 9000 RSP and the SecGW
running in a virtual machine on the VSM.
This command must be associated with the Service Redundancy Protocol (SRP) context.
A maximum of one HSRP monitor is supported per VPC-VSM instance.
running in a virtual machine on the VSM.
This command must be associated with the Service Redundancy Protocol (SRP) context.
A maximum of one HSRP monitor is supported per VPC-VSM instance.
Important:
The above parameters must match those of the HSRP configuration in the ASR 9000 RSP.
Example