Cisco Cisco Packet Data Interworking Function (PDIF)
SGSN Service Configuration Mode Commands
▀ ran-protocol
▄ Command Line Interface Reference, StarOS Release 16
8366
ran-protocol
This command specifies the IuPS service for the SGSN service to use for communication with the RAN.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > SGSN Service Configuration
configure > context context_name > sgsn-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sgsn-service)#
Syntax
ran-protocol iups-service iups_srvc [ context ctx_name ]
no ran-protocol iups-service
no
Removes the IuPS service information from the SGSN service configuration.
iups-service
iups_srvc
Specifies the name of an IuPS service already configured on the system.
iups_srvc
: Enter an alphanumeric string of 1 to 63 characters.
ctx_name
ctx_name
: Enter the name of the IuPS context, an alphanumeric string of 1 to 63 characters.
Usage
Use this command to configure the IuPS service context that the current SGSN service will use to
communicate with the RAN. Up to 8 definitions can be defined for a single SGSN service to allow for
multiple PLMNs support.
communicate with the RAN. Up to 8 definitions can be defined for a single SGSN service to allow for
multiple PLMNs support.
Example
The following command configures the SGSN service to use an IuPS service named iups1 that has been
configured. in the same context as the SGSN service:
configured. in the same context as the SGSN service:
ran-protocol iups-service iups1