Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Ruledef Configuration Mode Commands
p2p traffic-type ▀
Command Line Interface Reference, StarOS Release 16 ▄
997
p2p traffic-type
This command allows you to define rule expressions to match the traffic type.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
[ no ] p2p traffic-type operator traffic_type
no
If previously configured, deletes the specified rule expression from the current ruledef.
operator
Specifies how to match.
operator
must be one of the following:
!=
: Does not equal
=
: Equals
traffic_type
Specifies the traffic type to match.
In 11.0 and later releases,
In 11.0 and later releases,
traffic_type
must be one of the following:
audio
file-transfer
im
unclassified
video
voipout
In 10.0 and earlier releases, the supported
traffic_type
was
voice
.
Usage
Use this command to configure the system to detect voice or non-voice P2P traffic. When the detection of a
protocol is enabled then the detection of sub-type is enabled by default.
protocol is enabled then the detection of sub-type is enabled by default.
Example
The following command configures the system to detect video traffic: