Cisco Cisco Packet Data Gateway (PDG)
HNB-GW Service Configuration Procedures
HNB-GW Service Configuration ▀
HNB-GW Administration Guide, StarOS Release 17 ▄
109
hnbgw-service <hnbgw_svc_name> -noconfirm
associate cbs-service <cbs_svc_name>
end
Notes:
<
ctxt_name
> is name of the source context in which HNB-GW service is configured.
<
hnbgw_svc_name
> is name of the HNB-GW service in which Open Access mode support is to be configured.
<
ip_address
> is the IPv4 type IP address of CBS service.
<
cbc_ip_address
> is the IPv4 type IP address of CBC server.
<
timer_in_secs
> is the SABP timer which is the wait time for receiving the SABP response from a peer. It is
an integer value between 1 and 300. If not configured, the default value for this timer is taken as 10 seconds.
Verifying HNB-GW Configuration
This section shows the configuration parameters configured for HNB-GW service.
Step 1
Verify that your HNB-GW services were created and configured properly by entering the following command in Exec
Mode:
Mode:
show hnbgw-service hnbgw-service <hnbgw_svc_name>}
The output of this command displays concise listing of HNB-GW service parameter settings as configured on
system.
system.
Step 2
Verify configuration errors of your HNB-GW services by entering the following command in Exec Mode:
show configuration errors section hnbgw-service}
The output of this command displays current configuration errors and warning information for the target
configuration file as specified for HNB-GW service
configuration file as specified for HNB-GW service