Cisco Cisco Packet Data Gateway (PDG)
HNB-GW Service Configuration Procedures
▀ IuCS over ATM Configuration
▄ HNB-GW Administration Guide, StarOS Release 17
114
IuCS over ATM Configuration
To configure IuCS-over-ATM on HNB-GW service:
Step 1
Configure and activate the SONET card by applying the example configuration in the Configuring the SONET Card
section.
section.
Step 2
Modify the configured SS7 Routing Domain configuration with Linkset Id and ATM parameters by applying the
example configuration in the Configuring Linkset Id and ATM Parameters section.
example configuration in the Configuring Linkset Id and ATM Parameters section.
Step 3
Configure ALCAP service and AAL2 node parameters by applying the example configuration in the Configuring
ALCAP Service and AAL2 Node section.
ALCAP Service and AAL2 Node section.
Step 4
Configure the ATM port and PVC for AAL2 and AAL5 type of PVC by applying the example configuration in the
Configuring the ATM Port section.
Configuring the ATM Port section.
Step 5
Modify the configured HNB-CS Network service configuration to associate ALCAP service for IuCS-over-ATM
support by applying the example configuration in the Associating ALCAP Service with HNB-CS Network Service
section.
support by applying the example configuration in the Associating ALCAP Service with HNB-CS Network Service
section.
Step 6
Save your configuration to flash memory, an external memory device, and/or a network location using the Exec mode
command
command
save configuration
. For additional information on how to verify and save configuration files, refer to the
System Administration Guide and the Command Line Interface Reference.
Configuring the SONET Card
To configure a SONET card for IuCS-over-ATM facility, apply the following example configuration:
configure
card <sonet_card_num>
framing {sonet | SDH}
no shutdown
end
Notes:
For other configuration procedures of ATM card, refer Creating and Configuring ATM Interfaces and Ports
section in System Administration Guide.
For more commands and keyword options, refer Command Line Interface Reference.
Configuring Linkset Id and ATM Parameters
To configure the linkset id and ATM parameters you need to modify existing SS7 Routing domain configuration by
applying the following example:
applying the following example:
configure