Cisco Cisco ASR 5000
Description
Required Information
An identification string from 1 to 255 characters (alpha and/or numeric)
by which the Gxa origin host is recognized by the system.
by which the Gxa origin host is recognized by the system.
Origin host name
The IPv6 address of the Gxa interface.
Origin host address
The Gxa endpoint name described above.
Peer name
The Gxa origin realm name described above.
Peer realm name
The IPv6 address and port number of the PCRF.
Peer address and port number
The Gxa endpoint name described above.
Route-entry peer
STa Interface Configuration (to 3GPP AAA server)
An identification string between 1 and 79 characters (alpha and/or numeric)
by which the interface is recognized by the system.Multiple names are
needed if multiple interfaces will be configured.
by which the interface is recognized by the system.Multiple names are
needed if multiple interfaces will be configured.
Interface name
IPv4 addresses assigned to the interface.Multiple addresses and subnets
are needed if multiple interfaces will be configured.
are needed if multiple interfaces will be configured.
IP address and subnet
The physical port to which the interface will be bound. Ports are identified
by the chassis slot number where the line card resides followed by the
number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.A single physical port
can facilitate multiple interfaces.
by the chassis slot number where the line card resides followed by the
number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.A single physical port
can facilitate multiple interfaces.
Physical port number
Used when configuring static IP routes from the management interface(s)
to a specific network.
to a specific network.
Gateway IP address
STa Diameter Endpoint Configuration
An identification string from 1 to 63 characters (alpha and/or numeric) by
which the STa Diameter endpoint configuration is recognized by the
system.
which the STa Diameter endpoint configuration is recognized by the
system.
End point name
An identification string between 1 through 127 characters.The realm is the
Diameter identity. The originator\'s realm is present in all Diameter
messages and is typically the company or service name.
Diameter identity. The originator\'s realm is present in all Diameter
messages and is typically the company or service name.
Origin realm name
An identification string from 1 to 255 characters (alpha and/or numeric)
by which the STa origin host is recognized by the system.
by which the STa origin host is recognized by the system.
Origin host name
The IPv6 address of the STa interface.
Origin host address
The STa endpoint name described above.
Peer name
The STa origin realm name described above.
Peer realm name
The IPv6 address and port number of the PCRF.
Peer address and port number
The STa endpoint name described above.
Route-entry peer
Rf Interface Configuration (to off-line charging server)
HSGW Administration Guide, StarOS Release 19
41
HSGW Configuration
Information Required