Cisco Cisco Packet Data Interworking Function (PDIF)
HeNB-GW Service Configuration Procedures
▀ HeNB-GW Service Configuration
▄ HeNB-GW Administration Guide, StarOS Release 18
54
Network GTP-U service and will be associated with the HeNB-GW Access Service in case s1-U relay is
enabled.
enabled.
<
secondary1_ipv4_addr
> is the IPV4 type address defined under the <
interface_name
> interface and
being bound to the <
gtpu_svc_name1
> GTP-U service.
<
secondary2_ipv4_addr
> is the IPV4 type address defined under the <
interface_name
> interface and
being bound to the <
gtpu_svc_name2
> GTP-U service.
<
henb_network_svc_name
> is the HeNB-GW Network service name
<
secondary3_ipv4_addr
> is the IPv4 type address used to bind with the S1-MME interface.
<
mme_pool_name
> is the MME pool name as defined while the LTE policy configuration.
Important:
This MME pool is associated with the HeNB-GW network service.
<
lte_policy_tai_db
> is the tracking area information database name as defined while the LTE policy
configuration.
Important:
This tracking area information database is associated with the HeNB-GW
network service.
<
henb_access_svc_name
> is the name of the HeNB-GW Access service name.
<
primary_ipv4_addr
> is the IPv4 type primary address used to bind with the S1-MME interface for this
HeNB-GW access service.
s1u-relay
enables the S1-U relay functionality by the HeNB-GW service. When configured, user enters into
S1-U relay configuration mode. In this mode user has to configure associations to the Access and Network
GTP-U services for S1-U relay. When s1-u relay is enabled, the association to ingress and egress GTP-U
services is considered as a critical configuration for the HeNB-GW Access service. When S1-U relay is
enabled, both Access and Network GTP-Uu services need to be in STARTED state for the HeNB-GW Access
service to START.
GTP-U services for S1-U relay. When s1-u relay is enabled, the association to ingress and egress GTP-U
services is considered as a critical configuration for the HeNB-GW Access service. When S1-U relay is
enabled, both Access and Network GTP-Uu services need to be in STARTED state for the HeNB-GW Access
service to START.
Important:
Changing the S1-U Relay configuration is a disruptive operation. The HeNB-GW
Service is re-started.
IPSec Configuration
Use the following example to configure the IPSec configuration which goes with the Security Gateway (SeGW)
configuration on the HeNB-GW Access Service.
configuration on the HeNB-GW Access Service.
For EAP-AKA Authentication Only
Configure
context <ctxt_name>
eap-profile <eap_profile_name>
mode authenticator-pass-through