Cisco Cisco Packet Data Interworking Function (PDIF)
P-GW Changes in Release 17
P-GW Enhancements for 17.3 ▀
Release Change Reference, StarOS Release 17 ▄
361
CSCus82761 - Charging Id in GTPv2 S2b/S2a
Feature Changes
Charging ID Sent in Create-Session-Response and Create-Bearer-Request
Introduced charging ID IE in S2b/S2a-GTPv2 as part of CDR support for 3GPP compliance for WiFi.
Previous Behavior: The P-GW did not send a charging-id in Create-Session-Response and Create-Bearer-Request
over S2b/S2a.
over S2b/S2a.
New Behavior: The P-GW will send a charging-id in Create-Session-Response and Create-Bearer-Request over
S2b/S2a.
S2b/S2a.
CSCut22844 - SegFault: libc.so.6/__strlen_sse2_bsf()
Feature Changes
Behavior Change in APN Removal
Previous Behavior: Earlier, while removing APN using the
no apn <apn_name>
command, all active and inactive
subscribers would get deleted with warning.
New Behavior: Now, active or inactive subscribers are not deleted when you try to remove an APN using the
command
command
no apn <apn_name>
. APN removal is not allowed if active or inactive subscribers are present and an error
message is displayed.
Customer Impact: APN removal is not allowed if already some active or inactive subscribers are present for the APN.
Command Changes
no apn
Modification has been made to the command
no apn
, earlier all active/inactive subscribers were deleted with a warning
message. With the new modification, the APN removal is not allowed and the following error message is displayed:
“Error: Clear all subscribers connected to the APN <apn_name> before removing it from configuration”.
configure
context context_name
no apn apn_name
end
Notes:
If
-noconfirm
keyword was used with
no apn <apn_name>
, earlier active or inactive subscribers were deleted
without prompting any warning or confirmation. With new modification, the APN removal is not allowed and the
following error message is displayed:
following error message is displayed:
“Error: Clear all subscribers connected to the APN <apn_name> before removing it from configuration”.