Cisco Cisco Packet Data Interworking Function (PDIF)
SecGW Changes in Release 17
▀ SecGW Enhancements for 17.0
▄ Release Change Reference, StarOS Release 17
460
Command Changes – Anchor Route Configuration
ip anchor-route
This command associates the anchor IP address and physical IP address for this route. The command syntax is as
follows:
follows:
config
context wsg_context
ip anchor-route anchor-ip-addr/32 physical-ip-addr interface name
Notes:
anchor-ip-addr is the virtual IP address used on the private network side of both the active and standby VSMs.
physical-ip-addr is the unique IP address configured for the physical interface on each VSM.
Command Changes – HSRP
HSRP configuration parameters include:
Interface name
Address Family Identifier (AFI) type (IPv4 or IPv6)
HSRP group number
Important:
The above parameters must match those of the HSRP configuration in the ASR 9000 RSP.
The following limits also apply to the HSRP configuration
A maximum of one HSRP monitor is supported per QvPC-VSM instance.
The monitor hsrp command is associated with the SRP context.
monitor hsrp
The syntax for the monitor hsrp command is as follows:
config
context srp_context
monitor hsrp interface ifname afi-type type group hsrp_group
CSCum19793 - WSG as IKEv2 Initiator
Feature Changes
WSG as IKEv2 Initiator