Cisco Cisco Packet Data Interworking Function (PDIF)

 

▄  Release Change Reference, StarOS Release 17 

A new keyword “apn-access-denied-no-subscription” is added to this command for mapping the Diameter result-codes 
with this GTP cause code. 

configure 

  require active-charging 

  active-charging service service_name 

     credit-control  service_name 

        diameter result-code { authorization-rejected | credit-limit-reached | end-user-
service-denied | user-unknown } use-gtp-cause-code apn-access-denied-no-subscription 

        default diameter result-code { authorization-rejected | credit-limit-reached | 
end-user-service-denied | user-unknown } use-gtp-cause-code 

        end 

Notes: 



 

If this CLI command is configured and if the CCR-U is received with auth-rejected(5003) or credit-limit-

reached(4012) or user-unknown(5030) or end-user-service-denied(4010), then the gtp result-code is sent as 
“apn-access-denied-no-subscription”. 



 

Earlier, GTP_NO_RESOURCES_AVAILABLE was sent as a default GTP result code. Now with this CLI 

configured and the corresponding Diameter result codes received, 
GTP_APN_ACCESS_DENIED_NO_SUBSCRIPTION is sent on GTPC.  



 

This CLI command is applicable only for CCR-I messages. 

Applicable Products: GGSN, MME, P-GW 

It has been verified that the Rate Limiting Function (RLF) is supported on S6b Diameter interface. That is, the RLF 
framework is used by S6b for rate-limiting/throttling Diameter messages on S6b interface. 

Applicable Products: GGSN, HA, IPSG, PDSN, P-GW