Cisco Cisco Packet Data Interworking Function (PDIF)
Configuring the SaMOG Gateway
▀ Configuring the System to Perform as a SaMOG Gateway
▄ SaMOG Administration Guide, StarOS Release 19
112
network protocol (PMIPv6), and LMA address (CGW service’s bind address) to be sent in the Cisco Vendor-specific
attributes to WLC. The WLC uses this information to build the PMIPv6 PBU to the SaMOG gateway when the
attributes to WLC. The WLC uses this information to build the PMIPv6 PBU to the SaMOG gateway when the
aaa-
override
option is enabled on the Cisco WLC. These attributes are not sent when the custom70 dictionary is
configured.
Notes:
Use the
ue-address
command to configure Layer 3 IP access-type only.
When the
associate dhcpv6-service dhcpv6_service_name
is configured, SaMOG will use the bind
address configured under the DHCPv6 Service Configuration Mode for DHCPv6 server functionality.
Configuring the LTE Policy
The LTE Policy Configure the LTE policy by applying the example configuration below.
config
operator-policy policy-name
apn network-identifier apn_net_id apn-profile apn_profile_name
associate call-control-profile profile_id
exit
call-control-profile profile_name
accounting mode gtpp
authenticate context context_name aaa-group aaa_group_name
accounting context context_name aaa-group aaa_group_name
accounting context context_name gtpp-group gtpp_group_name
assocaite accounting-policy policy_name
exit
apn-profile profile_name
accounting mode none
local-offload
address-resolution-mode local
pgw-address IP_address
qos default-bearer qci qci_id
qos default-bearer arp arp_value preemption-capability may vulnerability not-
preemptable
preemptable