Cisco Cisco Packet Data Interworking Function (PDIF)
Reverse Route Injection
▀ HSRP
▄ SecGW Administration Guide, StarOS Release 18
64
HSRP Configuration
Parameters
HSRP configuration parameters include:
Interface name
Address Family Identifier (AFI) type (IPv4 or IPv6)
HSRP group number
Important:
The above parameters must match those of the HSRP configuration in the ASR 9000 RSP.
The following limits also apply to the HSRP configuration
A maximum of one HSRP monitor is supported per VPC-VSM instance.
The monitor hsrp command is associated with the SRP context.
monitor hsrp Command
The syntax for the monitor hsrp command is as follows:
config
context srp_context
monitor hsrp interface ifname afi-type type group hsrp_group
StarOS Configuration
HSRP monitoring must be enabled in the SRP configuration. A sample configuration is provided below.
Important:
You must configure HSRP for each VPC-VSM instance (StarOS VM) on the active and standby
VSMs.
configure
context srp
service-redundancy-protocol
checkpoint session duration 30
route-modifier threshold 10
priority 10
monitor hsrp interface GigabitEthernet0/0/1/1 afi-type ipv4 hsrp-group 4
peer-ip-address 88.88.88.36