Cisco Cisco Packet Data Interworking Function (PDIF)
Reverse Route Injection
▀ High Availability for RRI
▄ SecGW Administration Guide, StarOS Release 17
54
interface_name specifies the egress interface.
ip/ipv6 rri-route Command
This Context Configuration mode CLI command configures High Availability Routing Parameters for Reverse Route
Injection.
Injection.
configure
context context_name
{ ip | ipv6 } rri-route network-mode { L2 | L3 } { clear_loopback_ip |
rri-ip virtual_ip_address } { ip_address | next-hop nexthop_address }
interface interface_name [ vrf vrf_name ]
rri-ip virtual_ip_address } { ip_address | next-hop nexthop_address }
interface interface_name [ vrf vrf_name ]
end
Notes:
This command is mandatory in the following scenarios:
L2 Intrachassis HA (where loopback IP is configured)
L3 Interchassis HA (where IP is configured)
ip_address, virtual_ip_address and nexthop_address can be specified in IPv4 dotted-decimal (ip rri-route) or
IPv6 colon-separated-hexadecimal (ipv6 rri-route) format.
The next hop IP address is not required for point-to-point and tunnel interfaces.
interface_name specifies the egress interface.
ip/ipv6 sri-route Command
This Context Configuration mode command configures L3 High Availability Service Route Injection parameters:
configure
context context_name
{ ip | ipv6 } sri-route sri-ip network_address next hop nexthop_address
interface interface_name [ vrf vrf_name ]
interface interface_name [ vrf vrf_name ]
end
Notes:
network_address and nexthop_address are specified in IPv4 dotted-decimal (ip sri-route) or IPv6 colon-
separated hexadecimal (ipv6 sri-route) notation.
The next hop IP address is not required for point-to-point and tunnel interfaces.
interface_name specifies the egress interface.