Cisco Cisco Packet Data Gateway (PDG) Prospecto
Call Control Profile Configuration Mode
peer-mme ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
1913
peer-mme
Configures a peer MME address. S4-SGSN operators can use this command if they wish to bypass DNS resolution to
obtain the MME address.
obtain the MME address.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Call Control Profile Configuration
configure > call-control-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-call-control-profile-profile_name)#
Syntax
peer-mme { mme-groupid <lac val> mme-code <rac value> | tac tac } prefer { fallback-for-
dns | local } address { <ipv4_address> | <ipv6_address> } interface { gn [ s3 ] | s3 [ gn
] }
dns | local } address { <ipv4_address> | <ipv6_address> } interface { gn [ s3 ] | s3 [ gn
] }
remove peer-mme { mme-groupid <lac val> mme-code <rac value> | tac tac } address [
<ipv4_address> | <ipv6_address> [ interface { gn [ s3 ] | s3 [ gn ] } ]
<ipv4_address> | <ipv6_address> [ interface { gn [ s3 ] | s3 [ gn ] } ]
remove
Removes a specified peer MME from the call control profile. The
interface
keyword is optional. If it is not
used, the entire interface will be deleted.
mme-groupid <lac val>
Specifies the location area code value of the peer MME. The MME group ID of the peer MME maps to the
LAC value when GUTI is converted to P-TMSI.
LAC value when GUTI is converted to P-TMSI.
<lac val>
must be an integer from 1 to 65535.
mme-code <rac value>
Specifies the routing area code value of the peer MME. The MME code of the peer MME maps to the RAC
value when GUTI is converted to P-TMSI.
value when GUTI is converted to P-TMSI.
<rac value>
must be an integer from 0 to 255.
tac tac
Optional. Specifies the Tracking Area Code (TAC) of the target eNodeB that is used for UTRAN to E-
UTRAN (SGSN to MME) SRNS relocation across the S3 interface. Valid entries are 1 to 65535. This setting
applies only if SRNS relocation first has been configured via the
UTRAN (SGSN to MME) SRNS relocation across the S3 interface. Valid entries are 1 to 65535. This setting
applies only if SRNS relocation first has been configured via the
srns-inter
and/or
srns-intra
commands in Call Control Profile Configuration Mode.