Cisco Cisco Packet Data Gateway (PDG) Prospecto
Credit Control Configuration Mode Commands
▀ diameter send-ccri
▄ Cisco ASR 5x00 Command Line Interface Reference
2660
diameter send-ccri
This command configures when to send an initial Credit Control Request (CCR-I) for the subscriber session.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Credit Control Configuration
active-charging service service_name > credit-control
Entering the above command sequence results in the following prompt:
[local]host_name(config-dcca)#
Syntax
diameter send-ccri { session-start | traffic-start }
default diameter send-ccri
default
Configures this command with the default setting.
Default:
Default:
session-start
session-start
Sends CCR-I when the PDP context is being established (on receiving Create-PDP-Context-Request).
traffic-start
Delays sending CCR-I until the first data packet is received from the subscriber.
Important:
Please note that the CCR-I will be sent only with the default rulebase and not with Rulebase list even
if the
rulebase-list
configuration is enabled. When the
rulebase-list
command is used in conjunction with
diameter send-ccri traffic-start
command, the former one's function is invalidated. The rulebase-list is used
to allow the OCS to select one of the rulebases from the list configured during the session setup. But in case of
send-
ccri traffic-start
the CLI causes the session setup to complete without OCS interaction. For more information on
rulebase-list
command, please see the ACS Configuration Mode Commands chapter of the Command Line
Interface Reference.
Usage
Use this command to configure when to send CCR-Initial for the subscriber session.
Example
The following command configures to send CCR-I on traffic detection and not on context creation:
diameter send-ccri traffic-start