Cisco Cisco Packet Data Gateway (PDG) Prospecto
CSCF Access Profile Configuration Mode Commands
pcrf-policy-control ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
2867
pcrf-policy-control
Enables PCRF policy control for this access profile. By default, this command is disabled.
Product
SCM (P-CSCF, A-BG)
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > CSCF Access Profile Configuration
configure > context context_name > cscf access-profile { default | name profile_name }
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-cscf-access-profile)#
Syntax
[ default | no ] pcrf-policy-control
default | no
PCRF policy control is disabled.
Usage
Use this command to enable or disable PCRF policy control for this access profile.
When a subscriber sends a REGISTER message, P-CSCF extracts the access-type mentioned in the P-
Access-Network-Info and stores it. When P-CSCF needs to trigger an AAR for a subscriber, either for
signaling-loss-detection or media-authorization, it will check if pcrf-policy-control is enabled for that
subscriber's stored access-type. If pcrf-policy-control is enabled, AAR will be sent to PCRF for that
subscriber.
When a subscriber sends a REGISTER message, P-CSCF extracts the access-type mentioned in the P-
Access-Network-Info and stores it. When P-CSCF needs to trigger an AAR for a subscriber, either for
signaling-loss-detection or media-authorization, it will check if pcrf-policy-control is enabled for that
subscriber's stored access-type. If pcrf-policy-control is enabled, AAR will be sent to PCRF for that
subscriber.