Cisco Cisco Packet Data Gateway (PDG) Prospecto
ACS Charging Action Configuration Mode Commands
▀ content-id
▄ Cisco ASR 5x00 Command Line Interface Reference
386
content-id
This command allows you to specify the content ID to use in the generated billing records, as well as the AVP used by
the Credit Control Application, such as the “Rating-Group” AVP for use by the Diameter Credit Control Application
(DCCA).
the Credit Control Application, such as the “Rating-Group” AVP for use by the Diameter Credit Control Application
(DCCA).
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Charging Action Configuration
active-charging service service_name > charging-action charging_action_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-charging-action)#
Syntax
content-id content_id
no content-id
no
Removes the content ID configuration from the charging action.
content_id
Specifies the content ID for credit control service.
In 12.1 and earlier releases
In 12.1 and earlier releases
content_id
must be an integer from 1 through 65535.
In 12.2 and later releases,
content_id
must be an integer from 1 through 2147483647.
Usage
This command specifies an optional content ID to use in the generated billing records. This identifier assists
the carrier’s billing post processing and also used by credit-control system to use independent quotas for
different value of
the carrier’s billing post processing and also used by credit-control system to use independent quotas for
different value of
content-id
.
If the specified ruledef uses the
if-protocol
command to select a value for content ID, then the
content_id
specified through this command is not used for billing record generation.
Important:
For more information on
content-id
, refer to the
if-protocol
command in the ACS Ruledef
Configuration Mode Commands chapter.
Example
The following command sets the content ID in the current charging action to
23
:
content-id 23