Cisco Cisco Packet Data Gateway (PDG) Prospecto
Exec Mode Commands (D-S)
link-aggregation port switch to ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
3895
link-aggregation port switch to
When a link aggregation group (LAG) contains two sets of ports with each connecting to a different Ethernet switch,
this command allows you to change the status of the active distributing ports. (ASR 5x00 only)
this command allows you to change the status of the active distributing ports. (ASR 5x00 only)
Default: none.
Product
All
Privilege
Security Administrator, Administrator, Operator
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
link-aggregation port switch to slot# / port#
slot#
Identifies the physical chassis slot where the line card or MIO card is installed.
port#
Identifies the physical port on the line card or MIO card to automatically switch to.
Usage
This command is subject to the following restrictions:
slot#/port#
must support LAG.
slot#/port#
must be configured with LAG.
slot#/port#
must not be actively distributing.
slot#/port#
must have negotiated a partner while in standard mode.
slot#/port#
’s partner must have a priority equal to or greater than itself.
slot#/port#
’s partner bundle must have bandwidth in standard mode equal to or greater than itself.
Switching to
slot#/port#
must not violate preference within hold-time in standard mode.
Example
link-aggregation port switch to 17/2
link-aggregation port switch to 5/12