Cisco Cisco Packet Data Gateway (PDG) Prospecto
ACS Charging Action Configuration Mode Commands
ip vlan ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
403
ip vlan
This command allows you to configure the VLAN identifier to be associated with the subscriber traffic in the
destination context.
destination context.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Charging Action Configuration
active-charging service service_name > charging-action charging_action_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-charging-action)#
Syntax
ip vlan vlan_id
{ default | no } ip vlan
default
Configures this command with its default setting.
Default: Disable this IP VLAN configuration. Same as
Default: Disable this IP VLAN configuration. Same as
no ip vlan
command.
no
If previously configured, deletes the IP VLAN configuration in the current charging action. Whatever value is
configured for the VLAN tag in the subscriber configuration or IP pool configuration (or no VLAN tag if
there is no configuration elsewhere) is used.
configured for the VLAN tag in the subscriber configuration or IP pool configuration (or no VLAN tag if
there is no configuration elsewhere) is used.
vlan_id
Specifies the VLAN ID.
vlan_id
must be an integer from 1 through 4094.
Usage
This command configures the subscriber VLAN ID which is used with the assigned address for the subscriber
session to receive packets. If the IP pool from which the address is assigned is configured with a VLAN ID,
then this subscriber configured VLAN ID overrides it.
Subscriber traffic can be routed to specific VLANs based on the configuration of their user profile. Using this
functionality provides a mechanism for routing all traffic from a subscriber over the specified VLAN. All
packets destined for the subscriber must also be sent using only IP addresses valid on the VLAN or they will
be dropped.
session to receive packets. If the IP pool from which the address is assigned is configured with a VLAN ID,
then this subscriber configured VLAN ID overrides it.
Subscriber traffic can be routed to specific VLANs based on the configuration of their user profile. Using this
functionality provides a mechanism for routing all traffic from a subscriber over the specified VLAN. All
packets destined for the subscriber must also be sent using only IP addresses valid on the VLAN or they will
be dropped.
Example
The following command sets the IP VLAN range to go up to
500
:
ip vlan 500