Cisco Cisco Packet Data Gateway (PDG) Prospecto
Global Configuration Mode Commands (T-threshold phspc)
terminal ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
5285
terminal
Configures the console port on the SPIO.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
terminal [ carrierdetect { off | on } | databits { 7 | 8 } | flowcontrol { hardware { off
| on } | none } | parity { even | none | odd } | speed { 115200 | 19200 | 38400 | 57600 |
9600 } | stopbits { 1 | 2 } ]
| on } | none } | parity { even | none | odd } | speed { 115200 | 19200 | 38400 | 57600 |
9600 } | stopbits { 1 | 2 } ]
carrierdetect { off | on }
Specifies whether or not the console port is to use Data Carrier Detect (DCD) when connecting to a terminal.
Default: off
Default: off
off
: Do not use DCD.
on
: Use DCD.
databits { 7 | 8 }
Specifies the number of data bits used to transmit and receive characters.
Default:
Default:
8
7
: Use 7 databits to transmit and receive characters.
8
: Use 8 databits to transmit and receive characters.
flowcontrol { hardware { off | on } | none }
Specifies how the flow of data is controlled between the SPIO and a terminal.
Default:
Default:
none
hardware
: Enables or disables the use of hardware-based flow control
off
: Disables the use of Ready to Send (RTS) and Clear to Send (CTS).
on
: Enables the use of Ready to Send (RTS) and Clear to Send (CTS).
none
: Disables the use of DCD, RTS and CTS.
parity { even | none | odd }
Specifies the type of error checking used on the port.
Default: none
Default: none
even
- Enables error checking by setting the parity bit to 1 (if needed) making the number of 1s in the data
bits even.
none
- Disables error checking.