Cisco Cisco Packet Data Gateway (PDG) Prospecto
Global Configuration Mode Commands (T-threshold phspc)
▀ threshold contfilt-block
▄ Cisco ASR 5x00 Command Line Interface Reference
5332
threshold contfilt-block
Configures, alarm or alert thresholds for Content Filtering rating operations blocked during a polling interval at which
the threshold are raised or cleared.
the threshold are raised or cleared.
Product
CF
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold contfilt-block high_thresh_value [ clear low_thresh_value ]
default threshold contfilt-block
default
Configures this command with the default threshold settings.
high_thresh
Specifies the high threshold for number of rating operations blocked for content filtering service that must be
met or exceeded at the end of the polling interval to generate an alert or alarm.
met or exceeded at the end of the polling interval to generate an alert or alarm.
high_thresh
is measured in numbers of total rating operations blocked and is an integer from 0 through
1000000. A value of 0 disables the threshold.
clear
low_thresh
Specifies the low threshold for the total number of rating operations blocked for a content filtering service
that maintains a previously generated alarm condition. If the threshold falls below Specifies the low threshold
within the polling interval, a clear alarm is generated.
that maintains a previously generated alarm condition. If the threshold falls below Specifies the low threshold
within the polling interval, a clear alarm is generated.
low_thresh
is measured in numbers of total rating operations blocked and is an integer from 0 through
1000000. A value of 0 disables the threshold.
Default: 0
Default: 0
Usage
Use this command to configure the threshold for a content filtering service to generates alerts or alarms based
on the number of rating operations blocked for a content filtering service during the polling interval.
If a trigger condition exists at the end of the polling interval, the alert or alarm will not be generated until the
end of the polling interval.
Refer to the
on the number of rating operations blocked for a content filtering service during the polling interval.
If a trigger condition exists at the end of the polling interval, the alert or alarm will not be generated until the
end of the polling interval.
Refer to the
threshold poll contfilt-block
command to configure the polling interval and the
threshold monitoring
command to enable thresholding for this value.
Example