Cisco Cisco Packet Data Gateway (PDG) Prospecto
Global Configuration Mode Commands (T-threshold phspc)
▀ threshold cpu-orbs-warn
▄ Cisco ASR 5x00 Command Line Interface Reference
5344
threshold cpu-orbs-warn
Configures thresholds for generating warning-level alerts or alarms based on the percentage of CPU utilization by the
Object Request Broker System (ORBS) software task.
Object Request Broker System (ORBS) software task.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold cpu-orbs-warn high_thresh [ clear low_thresh ]
[ default ] threshold cpu-orbs-warn
default
Restores this parameter to its default setting.
high_thresh
Default: 50
Specifies the high threshold percent of CPU utilization by the ORBS software task that must be exceeded as
measured at the time of polling to generate a warning-level alert or alarm.
Specifies the high threshold percent of CPU utilization by the ORBS software task that must be exceeded as
measured at the time of polling to generate a warning-level alert or alarm.
high_thresh
is measured in percentage of total CPU utilization and is an integer from 0 through 100. A
value of 0 disables the threshold.
clear
low_thresh
Default: 50
Specifies the low threshold percent of CPU utilization by the ORBS software task that maintains a previously
generated alarm condition. If the percentage is measured as less than or equal to Specifies the low threshold
at the time of polling, a clear alarm will be generated.
Specifies the low threshold percent of CPU utilization by the ORBS software task that maintains a previously
generated alarm condition. If the percentage is measured as less than or equal to Specifies the low threshold
at the time of polling, a clear alarm will be generated.
low_thresh
is measured in percentage of total CPU utilization and is an integer from 0 through 100. A
value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to Specifies the low threshold.