Cisco Cisco Packet Data Gateway (PDG) Prospecto
Global Configuration Mode Commands (threshold poll commands A - N)
▀ threshold poll a11-rrq-msg-discard interval
▄ Cisco ASR 5x00 Command Line Interface Reference
5460
threshold poll a11-rrq-msg-discard interval
Configures the polling interval for PDSN service over which to count how many A11 Registration Request messages
are discarded.
are discarded.
Product
PDSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll a11-rrq-msg-discard intervalduration
default threshold poll a11-rrq-msg-discard interval
default
Restores the specified parameter to its default value 0 seconds.
interval
duration
Default: 0 seconds.
Specifies the amount of time (in seconds) that comprises the polling interval.
Specifies the amount of time (in seconds) that comprises the polling interval.
duration
is an integer from 60 through 900 in multiples of 30.
Usage
This command sets the time period over which to monitor the specified value for threshold crossing.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring
and other threshold commands for additional information on the
system’s support for thresholds in this chapter.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshPDSNSvcA11RRQMsgDiscard
command in this mode.
Example
The following command configures the polling interval to
600
seconds for the A11 RRQ message discard
threshold: