Cisco Cisco Packet Data Gateway (PDG) Prospecto
Global Configuration Mode Commands (threshold poll commands O - Z)
threshold poll port-high-activity interval ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
5585
threshold poll port-high-activity interval
Configures the polling interval in seconds over which to measure the overall percentage of port utilization.
Product
All
Privilege
Administrator Security Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll port-high-activity interval seconds
interval seconds
Configures the threshold polling interval in multiples of 30 seconds.
seconds
is an integer from 30 through
60000. Default is 300 seconds.
Usage
High port activity thresholds generate alerts or alarms based on the peak utilization percentage of each
configured port during the specified polling interval. This threshold is configured on a per-port basis. Alerts
or alarms are triggered for high port activity based on the following rules:
Enter condition: Actual percent peak utilization of a port is greater than or equal to the high threshold.
Clear condition: Actual percent peak utilization of a port is less than the low threshold.
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.This threshold is configured on a per-port basis configured using the port
configured port during the specified polling interval. This threshold is configured on a per-port basis. Alerts
or alarms are triggered for high port activity based on the following rules:
Enter condition: Actual percent peak utilization of a port is greater than or equal to the high threshold.
Clear condition: Actual percent peak utilization of a port is less than the low threshold.
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.This threshold is configured on a per-port basis configured using the port
port-type
slot#/port#
command syntax.
Important:
This command is not available on all platforms
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshPortHighActivity
command in this mode.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshPortHighActivity
command in this mode.
Example
Use the following example to configure the polling interval over which to measure for high port activity to
300
seconds: