Cisco Cisco Packet Data Gateway (PDG) Prospecto
LTE Emergency Profile Configuration Mode Commands
apn ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
6693
apn
Configures the name and PDN type of the access point name (APN) used for emergency PDN connections.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > LTE Policy Configuration > LTE Emergency Profile Configuration
configure > lte-policy > lte-emergency-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(lte-emergency-profile)#
Syntax
apn apn_name pdn-type { ipv4 | ipv4v6 | ipv6 }
no apn
no
Removes the selected APN from the profile.
apn_name
apn_name
specifies the name of a pre-configured APN profile to associate with this LTE emergency profile.
For more information on APNs, refer to the apn command in the Context Configuration Mode Commands
chapter.
chapter.
pdn-type { ipv4 | ipv4v6 | ipv6 }
Configures the packet data network type supported by the APN and this profile.
ipv4
: Specifies that the PDN supports IPv4 network traffic.
ipv4v6
: Specifies that the PDN supports both IPv4 and IPv6 network traffic.
ipv6
: Specifies that the PDN supports IPv6 network traffic.
Usage
Use this command to select the APN to be used for emergency bearer services. APNs are configured through
the APN Configuration mode. For more information regarding APN configuration mode commands, refer to
the APN Configuration Mode Commands chapter.
the APN Configuration mode. For more information regarding APN configuration mode commands, refer to
the APN Configuration Mode Commands chapter.
Example
The following command specifies that the APN named
apn-3.com
is to be used for emergency bearer
services and that the PDN supports IPv4 traffic only:
apn apn-3.com pdn-type ipv4