Cisco Cisco Packet Data Gateway (PDG) Prospecto
MME LAC Pool Area Configuration Mode Commands
hash-value ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
6861
default VLR has been configured, or if the default VLR is inactive, the MME selects any other available VLR
from the pool.
If the chosen VLR is active at the time of selection and then subsequently becomes inactive when the request
is sent to it, the current request fails. On the next request from the UE, the VLR selection mechanism is
applied again. A VLR that failed previously will only be selected again if it became active since the earlier
failure.
from the pool.
If the chosen VLR is active at the time of selection and then subsequently becomes inactive when the request
is sent to it, the current request fails. On the next request from the UE, the VLR selection mechanism is
applied again. A VLR that failed previously will only be selected again if it became active since the earlier
failure.
Example
The following command configures all hash values within a range of
0
to
500
to use a VLR named
vlr1
:
hash-value range 0 to 500 use-vlr vlr1
The following command configures hash values of
501
to use a VLR named
vlr2
:
hash-value 501 use-vlr vlr2
The following command configures all non-configured hash values to use a VLR named
vlr3
:
hash-value non-configured-values use-vlr vlr3