Cisco Cisco Packet Data Gateway (PDG) Prospecto
PCP Policy Control Configuration Mode Commands
▀ response-opcode
▄ Cisco ASR 5x00 Command Line Interface Reference
7460
response-opcode
This command allows you to configure various PCP Response Opcode options.
Product
ACS
NAT
PSF
Privilege
Security Administrator, Administrator
Exec > ACS Configuration > PCP Configuration > Port Control Protocol Service Policy Control Configuration
active-charging service service_name > pcp-service service_name > policy-control
Entering the above command sequence results in the following prompt:
[local]host_name(config-pcp-policy-control)#
Syntax
response-opcode { map | peer } [ error { long life-time long_life_time | short life-time
short_life_time } | success life-time succ_life_time ] +
short_life_time } | success life-time succ_life_time ] +
{ default | no } response-opcode [ map | peer ] +
default
Configures this command with its default setting.
map
Configures the lifetime for which Map mappings are available.
peer
Configures the lifetime for which Peer mappings are available.
error { long life-time long_life_time | short life-time short_life_time }
Configures the lifetime for long and short error cases, in seconds.
long_life_time
and
short_life_time
must be an integer from 30 through 7200.
success life-time succ_life_time
Configures the lifetime for successful long and short cases, in seconds.
succ_life_time
must be an integer from 30 through 7200.
peer
Configures this command with its default setting.