Cisco Cisco Packet Data Gateway (PDG) Prospecto
PDSN Service Configuration Mode Commands
▀ ppp
▄ Cisco ASR 5x00 Command Line Interface Reference
7554
ppp
Sets PPP tunneling parameters for subscribers in the current PDSN service.
Product
PDSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > PDSN Service Configuration
configure > context context_name > pdsn-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-pdsn-service)#
Syntax
ppp { tunnel-context context_name | tunnel-type { l2tp | none } }
[ no | default ] ppp tunnel-type
no
Enables/Disables the PPP tunneling parameters for subscribers in the current PDSN service.
default
Sets / Restores default value assigned for PPP tunneling parameters for subscribers in the current PDSN
service.
service.
tunnel-context
context_name
The name of the context that has a LAC service configured to handle all tunnels from this PDSN service.
tunnel-type
{
l2tp
|
none
}
l2tp
: Force all subscriber sessions in this PDSN service to use L2TP tunneling.
none
: Do not force L2TP tunneling. This is the default.
Important:
If the context specified by the
ppp tunnel-context
context_name
command does not have a
LAC service configured and
tunnel-type
is set to
l2tp
or the call is rejected.
Important:
If the PPP tunnel context has not been set or has been cleared with the
no ppp tunnel-context
command and
tunnel-type
is set to
l2tp
, the context where the current PDSN service resides is used. If that context
does not have a LAC service configured the call is rejected.
Usage
Use this command to enable or disable forced L2TP tunneling for all subscribers using this PDSN service.
Also use this command to define which context defines the L2TP tunneling parameters.
Also use this command to define which context defines the L2TP tunneling parameters.