Cisco Cisco Packet Data Gateway (PDG) Prospecto
S-GW Service Configuration Mode Commands
▀ associate
▄ Cisco ASR 5x00 Command Line Interface Reference
8146
associate
Associates the S-GW service with QoS and policy control and charging configurations.
Product
S-GW
SAEGW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > S-GW Service Configuration
configure > context context_name > sgw-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sgw-service)#
Syntax
associate { access-peer-map | accounting-policy name | egress-proto { gtp | gtp-pmip |
pmip } [ egress-context name [ egtp-service name ] [ mag-service name ] ] | ims-auth-
service name | ingress egtp-service name | qci-qos-mapping name | subscriber-map name
pmip } [ egress-context name [ egtp-service name ] [ mag-service name ] ] | ims-auth-
service name | ingress egtp-service name | qci-qos-mapping name | subscriber-map name
no associate { access-peer-map | accounting-policy | egress-proto [ egress-context [
egtp-service ] [ mag-service ] ] | ims-auth-service | ingress egtp-service | peer-map |
qci-qos-mapping | subscriber-map }
egtp-service ] [ mag-service ] ] | ims-auth-service | ingress egtp-service | peer-map |
qci-qos-mapping | subscriber-map }
no
Removes the specified association form the S-GW service.
access-peer-mapname
Associates the access/ingress side of the peer-map to the configured S-GW service.
name
must be an existing peer-map expressed as an alphanumeric string of 1 through 63 characters.
accounting-policy name
Associates the S-GW service with an accounting policy configured in the same context.
name
must be an existing accounting policy expressed as an alphanumeric string of 1 through 63 characters.
Accounting policies are configured through the
policy accounting
command in the Context
Configuration Mode.
egress-proto { gtp | gtp-pmip | pmip } [ egress-context name [ egtp-service name
] [ mag-service name ] ]
] [ mag-service name ] ]
Associates and configures the egress protocol for this S-GW service.
gtp
: Specifies that GTP is to be used for the S-GW service egress.
gtp-pmip
: Specifies that either GTP or PMIP is to be used for the S-GW service egress.
pmip
: Specifies that PMIP is to be used for the S-GW service egress.
egress-context
name
: Specifies that the context in this keyword is to be used for the S-GW service egress.