Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
ACS Ruledef Configuration Mode Commands
▀ rtp session-length
▄ Cisco ASR 5x00 Command Line Interface Reference
1016
rtp session-length
This command allows you to define rule expressions to match the total length of RTP sessions.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
[ no ] rtp session-length operator session_length
no
If previously configured, deletes the specified rule expression from the current ruledef.
operator
Specifies how to match.
operator
must be one of the following:
!=
: Does not equal
<=
: Lesser than or equals
=
: Equals
>=
: Greater than or equals
session_length
Specifies the RTP total session length (in bytes) to match.
In 8.1 and later releases,
In 8.1 and later releases,
session_length
must be an integer from 1 through 4000000000.
In release 8.0,
session_length
must be an integer from 1 through 40000000.
Usage
Use this command to define rule expressions to match the RTP total session length. The session-length is
calculated by adding together the “rtp pdu-length” values of all relevant packets.
calculated by adding together the “rtp pdu-length” values of all relevant packets.
Example
The following command defines a rule expression to match a total RTP session length of
200000
:
rtp session-length = 200000