Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
ACS Ruledef Configuration Mode Commands
rule-application ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
1049
rule-application
This command allows you to specify the purpose of a ruledef, such as for charging, post-processing, routing, and so on.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
rule-application { charging | post-processing | routing | tpo }
no rule-application
no
Disables the rule application configuration.
charging
Specifies that the current ruledef is for charging purposes.
Up to 2,048 rule definitions can be defined for the charging application in an Active Charging Service.
Default: Enabled
Up to 2,048 rule definitions can be defined for the charging application in an Active Charging Service.
Default: Enabled
post-processing
Important:
The
post-processing
keyword is available only in 8.3 and later releases.
Specifies that the current ruledef is for post-processing purposes. This enables processing of packets even if
the rule matching for them has been disabled.
the rule matching for them has been disabled.
routing
Specifies that the current ruledef is for routing purposes. Up to 256 rule definitions can be defined for routing
in an Active Charging Service. Default: Disabled
in an Active Charging Service. Default: Disabled
tpo
Important:
The Traffic Performance Optimization (TPO) in-line service is not supported in this release.