Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
Call Control Profile Configuration Mode
local-cause-code-mapping map-cause-code ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
1873
local-cause-code-mapping map-cause-code
Configures the operator-preferred GMM reject cause code to send to a UE in response to some failures.
Product
SGSN
Privilege
Administrator
Mode
Exec > Global Configuration > Call Control Profile Configuration
configure > call-control-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-call-control-profile-profile_name)#
Syntax
local-cause-code-mapping map-cause-code roaming-not-allowed gmm-cause-code gmm-cause
remove local-cause-code-mapping map-cause-code roaming-not-allowed
remove
Removes the specified, previously configured cause code mapping .
roaming-not-allowed
Instructs the SGSN to send a different GPRS mobility management (GMM) cause code to a UE when the
UE’s access request is rejected due to map cause ‘roaming not allowed’. Specify one of the GMM cause
codes listed below.
UE’s access request is rejected due to map cause ‘roaming not allowed’. Specify one of the GMM cause
codes listed below.
gmm-cause-code
Specifies the GPRS mobility management (GMM) cause code to return to a UE in access request Reject
messages. Replacement cause code options include:
messages. Replacement cause code options include:
gprs-serv-and-non-gprs-serv-not-allowed
gprs-serv-not-allowed
gprs-serv-not-in-this-plmn
location-area-not-allowed
network-failure
no-suitable-cell-in-this-la
plmn-not-allowed
roaming-not-allowed-in-this-la