Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
Channelized Port Configuration Mode Commands
▀ path
▄ Cisco ASR 5x00 Command Line Interface Reference
2052
path
This command configures the parameters that define the routing path for a DLCI. It must match with the DLCI
configuration parameters. The values entered with these commands should be noted as they will be needed to configure
the
configuration parameters. The values entered with these commands should be noted as they will be needed to configure
the
frame-relay
and
dlci
commands also in this configuration mode.
Product
SGSN
Privilege
Security Administrator, Administrator
Syntax
path path_id { ds1 connects | e1 connects } service-type { frame-relay | mtp2 } frame-
mapping multiplexing index# index# framing mode mapping-mode { bit-sync | byte-sync } [
timeslots slot# [ slot# ] | frame-relay [ intf-type intf_type [ lmi_type lmi_type ] ] ]
mapping multiplexing index# index# framing mode mapping-mode { bit-sync | byte-sync } [
timeslots slot# [ slot# ] | frame-relay [ intf-type intf_type [ lmi_type lmi_type ] ] ]
no path path_id { ds1 | e1 }connects
no
Deletes the routing path entry from the configuration.
path path_id
Identifies a specific path configuration that will be associated with a DLCI. The
path_id
must be an integer
from 1 to 3.
ds1 connects
|
e1 connects
Selects the channelization for the connection.
DS1: (AKA: T1) Is associated with North American networks and would be the best choice to work with the
SONET (can also work with SDH) framing selected with the
DS1: (AKA: T1) Is associated with North American networks and would be the best choice to work with the
SONET (can also work with SDH) framing selected with the
card
configuration command. DS1 splits the
path into 28 logical connections.
connects
: Defines the number of logical connections supported via the DS1. The selection must be an
integer from 1 to 28.
E1: is associated with European networks and would be associated with the SDH (can also work with
SONET) framing selected with the
E1: is associated with European networks and would be associated with the SDH (can also work with
SONET) framing selected with the
card
configuration command. E1 splits the path into 21 logical
connections.
connects
: Defines the number of logical connections supported via the E1. The selection must be an integer
from 1 to 21.
service-type { frame-relay | mtp2 }
Specifies the service type to be used for this path. When
multi-service
is enabled at the card level,
different services are supported at the path-level for this port. For additional information, refer to the
description of the
description of the
service-type
command in the Card Configuration Mode Commands chapter.
frame-relay
: Specifies Frame Relay mode for this path.
mtp2
: Specifies MTP2 service for this path.