Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
AAL2 Node Configuration Mode Commands
▀ point-code
▄ Cisco ASR 5x00 Command Line Interface Reference
218
point-code
This command configure the point code of adjacent AAL2 node in SS7 format address. This point code shall be filled in
the destination point-code (dpc) field of MTP3 routing label. This is required if signaling transport network is based on
MTP3-broadband (MTP3B).
the destination point-code (dpc) field of MTP3 routing label. This is required if signaling transport network is based on
MTP3-broadband (MTP3B).
Product
HNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > ALCAP Service Configuration > AAL2 Node Configuration
configure > context context_name > alcap-service service_name > aal2-node node_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-aal2-node-node_name)#
Syntax
[no] point-code point_code
no
Removes the configured point code from this AAL2 node configuration.
point_code
Defines the point code to assign to adjacent AAL2 node in SS7 format.
point_code:
value entered must adhere to the point code variant selected when the AAL2 node was
defined:
ITU Range 0.0.1 to 7.255.7
ANSI Range 0.0.1 to 255.255.255
TTC Range 0.0.1 to 15.31.255
a string of 1 to 11 combined digits ad period.
Usage
Use this command to configure configure the point code of adjacent AAL2 node in SS7 format address. This
point code shall be filled in the destination point-code (dpc) field of MTP3 routing label. This is required if
signaling transport network is based on MTP3-broadband (MTP3B).
A maximum of 16 point codes for adjacent AAL2 nodes can be configured in one ALCAP service.
point code shall be filled in the destination point-code (dpc) field of MTP3 routing label. This is required if
signaling transport network is based on MTP3-broadband (MTP3B).
A maximum of 16 point codes for adjacent AAL2 nodes can be configured in one ALCAP service.
Example
The following command configures the point code
4.121.5
for adjacent AAL2 node.
point-code 4.121.5
The following command removes the point code
4.121.15
from AAL2 node configuration.
no point-code 4.121.15