Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
Context Configuration Mode Commands S-Z
▀ threshold ha-service init-rrq-rcvd-rate
▄ Cisco ASR 5x00 Command Line Interface Reference
2612
threshold ha-service init-rrq-rcvd-rate
Sets an alarm or alert based on the average number of calls setup per second for an HA service.
Product
HA
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
threshold ha-service init-rrq-rcvd-rate high_thresh [ clear low_thresh ]
no threshold ha-service init-rrq-rcvd-rate
no
Deletes the alert or alarm.
high_thresh
Sets the high threshold average number of calls setup per second that must be met or exceeded within the
polling interval to generate an alert or alarm. It can be configured as an integer from 0 through 1000000.
Default: 0
polling interval to generate an alert or alarm. It can be configured as an integer from 0 through 1000000.
Default: 0
clear low_thresh
Sets the low threshold average number of calls setup per second that must be met or exceeded within the
polling interval to clear an alert or alarm. It can be configured as an integer from 0 through 1000000. Default:
0
polling interval to clear an alert or alarm. It can be configured as an integer from 0 through 1000000. Default:
0
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to set an alert or an alarm when the average number of calls set upper second is equal to or
less than a specified number of calls per second.
Alerts or alarms are triggered for the number of calls setup per second based on the following rules:
less than a specified number of calls per second.
Alerts or alarms are triggered for the number of calls setup per second based on the following rules:
Enter Condition: Actual number of calls setup per second > High Threshold
Clear Condition: Actual number of calls setup per second < Low Threshold
Example