Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
ACS Bandwidth Policy Configuration Mode Commands
group-id ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
371
group-id
This command allows you to configure the group ID for the current bandwidth policy.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Bandwidth Policy Configuration
active-charging service service_name > bandwidth-policy policy_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-bandwidth-policy)#
Syntax
group-id group_id direction { downlink | uplink } peak-data-rate peak_data_rate peak-
burst-size peak_burst_size violate-action { discard | lower-ip-precedence } [ committed-
data-rate committed_data_rate committed-burst-size committed_burst_size [ exceed-action {
discard | lower-ip-precedence } ] ]
burst-size peak_burst_size violate-action { discard | lower-ip-precedence } [ committed-
data-rate committed_data_rate committed-burst-size committed_burst_size [ exceed-action {
discard | lower-ip-precedence } ] ]
{ default | no } group-id group_id direction { downlink | uplink }
default
Configures this command with default settings for the specified group ID.
no
If previously configured, removes the specified group ID configuration from the current bandwidth policy.
group_id
Specifies the group ID.
group_id
must be an integer from 1 through 65535.
direction { downlink | uplink }
Specifies the direction for which bandwidth will be controlled.
peak-data-rate peak_data_rate
Specifies the peak data rate, in bits per second.
peak_data_rate
must be an integer from 1 through 4294967295.
Default: 0
peak-burst-size peak_burst_size
Specifies the peak burst size, in bytes.
peak_burst_size
must be an integer from 1 through 4294967295.
Default: 0