Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
ACS Configuration Mode Commands
fw-and-nat policy ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
467
fw-and-nat policy
This command allows you to create/configure/delete Firewall-and-NAT policies.
Important:
This command is available only in StarOS 8.1 and in StarOS 9.0 and later releases. This command
must be used to configure the Policy-based Stateful Firewall and NAT features.
Product
PSF
NAT
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration
active-charging service service_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs)#
Syntax
fw-and-nat policy policy_name [ -noconfirm ]
no fw-and-nat policy fw_nat_policy_name
no
If previously configured, deletes the specified Firewall-and-NAT policy from the active charging service.
Important:
When a Firewall-and-NAT policy is deleted, for all subscribers using the policy, Stateful Firewall
and NAT processing is disabled, also ACS sessions for the subscribers are dropped. In case of session recovery, the
calls are recovered but with Stateful Firewall and NAT disabled.
calls are recovered but with Stateful Firewall and NAT disabled.
fw_nat_policy_name
Specifies the Firewall-and-NAT policy to add/configure/delete.
fw_nat_policy_name
must be the name of a Firewall-and-NAT policy, and must be an alphanumeric string
of 1 through 63 characters. Each Firewall-and-NAT policy must have a unique name.
-noconfirm
Specifies that the command must execute without prompting for confirmation.
Usage
Use this command to create/configure/delete a Firewall-and-NAT policy.
On entering this command, the CLI prompt changes to:
On entering this command, the CLI prompt changes to:
[context_name]hostname(config-fw-and-nat-policy)#