Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
Cisco ASR 5x00 Command Line Interface Reference ▄
4815
Chapter 134
Firewall-and-NAT Action Configuration Mode Commands
The Firewall-and-NAT Action Configuration Mode enables configuring Stateful Firewall (FW) and Network Address
Translation (NAT) actions.
Translation (NAT) actions.
Mode
Exec > ACS Configuration > Firewall-and-NAT Action Configuration
active-charging service service_name > fw-and-nat action action_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-fw-and-nat-action)#
Important:
This configuration mode is only available in release 11.0 and later releases. This configuration mode
must be used to configure Action-based Stateful Firewall and NAT features.
Important:
The commands or keywords/variables that are available are dependent on platform type, product
version, and installed license(s).