Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
Cisco ASR 5x00 Command Line Interface Reference ▄
4821
Chapter 135
Firewall-and-NAT Policy Configuration Mode Commands
The Firewall-and-NAT Policy Configuration Mode enables configuring Stateful Firewall (FW) and Network Address
Translation (NAT) policies.
Translation (NAT) policies.
Mode
Exec > ACS Configuration > Firewall-and-NAT Policy Configuration
active-charging service service_name > fw-and-nat policy policy_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-fw-and-nat-policy)#
Important:
This configuration mode is only available in 8.1, 9.0, and later releases. This configuration mode
must be used to configure Policy-based Stateful Firewall and NAT features.
Important:
The commands or keywords/variables that are available are dependent on platform type, product
version, and installed license(s).