Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
Global Configuration Mode Commands (T-threshold phspc)
threshold asngw-network-entry-denial ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
5311
threshold asngw-network-entry-denial
Configures alarm or alert thresholds for denials of network entry to an MS within the ASN-GW service.
Product
ASN-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold asngw-network-entry-denial high_thresh [ clear low_thresh ]
default threshold asngw-network-entry-denial
high_thresh
Default: 0
Specifies the high threshold number of denial of network entry to an MS that must be met or exceeded within
the polling interval to generate an alert or alarm.
Specifies the high threshold number of denial of network entry to an MS that must be met or exceeded within
the polling interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 10000000. A value of 0 disables the threshold.
clear
low_thresh
Default: 0
Specifies the low threshold number of denial of network entry to an MS that maintains a previously generated
alarm condition. If the number of denials falls beneath the low threshold within the polling interval, a clear
alarm will be generated.
Specifies the low threshold number of denial of network entry to an MS that maintains a previously generated
alarm condition. If the number of denials falls beneath the low threshold within the polling interval, a clear
alarm will be generated.
low_thresh
is an integer from 0 through 10000000. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to set threshold limits to generate alerts or alarms based on the number of network entry
denials that occurred during the specified polling interval. Network denial messages are counted for an MS
with which the system is configured to communicate.
Alerts or alarms are triggered for network entry denials based on the following rules:
denials that occurred during the specified polling interval. Network denial messages are counted for an MS
with which the system is configured to communicate.
Alerts or alarms are triggered for network entry denials based on the following rules:
Enter condition: Actual number of failures is greater than or equal to the high threshold.
Clear condition: Actual number of failures is less than the low threshold.
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
of the polling interval.