Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
Global Configuration Mode Commands (T-threshold phspc)
▀ threshold cpu-load
▄ Cisco ASR 5x00 Command Line Interface Reference
5338
threshold cpu-load
Configures alarm or alert thresholds for monitoring packet processing card CPU loads using a 5-minute average
measurement. The threshold is enabled by enabling CPU resource monitoring.
measurement. The threshold is enabled by enabling CPU resource monitoring.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold cpu-load high_thresh [ clear low_thresh ]
high_thresh
Default: 0
If the monitored CPU load is greater than or equal to the specified number an alert is sent.
If the monitored CPU load is greater than or equal to the specified number an alert is sent.
high_thresh
must be an integer from 0 through 15.
clear
low_thresh
Default: 0
This is a low watermark value that sets the alarm clearing threshold value. If not present it is taken from the
first value.
This is a low watermark value that sets the alarm clearing threshold value. If not present it is taken from the
first value.
low_thresh
must be an integer from 0 through 15.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to Specifies the low threshold.
Usage
Use this command to set an alert when the card’s CPU load is equal to or greater than the number specified.
Alerts or alarms are triggered for CPU load based on the following rules:
Alerts or alarms are triggered for CPU load based on the following rules:
Enter condition: Actual CPU load is greater than or equal to the high threshold.
Clear condition: Actual CPU load is less than the low threshold.
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
threshold poll
command to configure the polling interval and the
threshold monitoring
command to enable thresholding for this value.
Important:
This command is not supported on all platforms.