Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
Global Configuration Mode Commands (T-threshold phspc)
▀ threshold nat-port-chunks-usage
▄ Cisco ASR 5x00 Command Line Interface Reference
5400
threshold nat-port-chunks-usage
Configures alarm or alert thresholds for the percentage of Network Address Translation (NAT) port chunk utilization.
Important:
This command is only available in 8.3 and later releases.
Product
NAT
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold nat-port-chunks-usage high_thresh [ clear low_thresh ]
default threshold nat-port-chunks-usage
default
Configures this command with the default threshold settings.
Default: 0—disabled
Default: 0—disabled
high_thresh
Specifies the high NAT-port-chunks-usage percentage threshold that must be met or exceeded within the
polling interval to generate an alert or alarm.
polling interval to generate an alert or alarm.
high_thresh
must be an integer from 0 through 100. A value of 0 disables the threshold.
Default: 0
clear low_thresh
Specifies the low nat-port-chunks-usage percentage threshold that must be met within the polling interval for
a clear alarm to be generated.
a clear alarm to be generated.
low_thresh
must be an integer from 0 through 100. A value of 0 disables the threshold. If not set, the
high_thresh
will be the high and low threshold setting.
Default: 0
Usage
Use this command to configure the NAT port chunk utilization threshold settings.
Example
The following command sets the NAT port chunk utilization threshold settings to a high of
75
% and a low of
15
%: