Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
Global Configuration Mode Commands (threshold poll commands A - N)
▀ threshold poll mme-auth-failure interval
▄ Cisco ASR 5x00 Command Line Interface Reference
5550
threshold poll mme-auth-failure interval
Configures the polling interval to count the MME Authentication Failure messages across all MME services in the
system.
system.
Product
MME
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll mme-auth-failure interval dur
default threshold poll mme-auth-failure interval
default
Restores the specified poll interval value to its default value of 900 seconds.
interval
dur
Default: 900 seconds.
Specifies the polling interval (in seconds) for counting MME Authentication Failure messages across all
MME services in the system.
Specifies the polling interval (in seconds) for counting MME Authentication Failure messages across all
MME services in the system.
dur
must be an integer from 30 through 60000 in multiples of 30.
Usage
Use this command to configure the polling interval to count the MME Auth Failure messages across all MME
services in the system to generate threshold value.
services in the system to generate threshold value.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring mme-service
and other threshold commands for additional
information on the system’s support for thresholds in this chapter.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshMMEAuthFail
command in this mode.
Example