Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
Global Configuration Mode Commands (threshold ppp - url-blacklisting)
threshold total-gprs-pdp-sessions ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
5659
threshold total-gprs-pdp-sessions
Configures alarm or alert thresholds for the total number of PDP contexts per GPRS sessions in the system.
Product
SGSN
Privilege
Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold total-gprs-pdp-sessions high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold number of total PDP contexts per GPRS session for all GPRS services that must
be met or exceeded within the polling interval to generate an alert or alarm.
Specifies the high threshold number of total PDP contexts per GPRS session for all GPRS services that must
be met or exceeded within the polling interval to generate an alert or alarm.
high_thresh
is an integer from 1 through 2000000. A value of 0 disables the threshold.
clear
low_thresh
Default: 0
Specifies the low threshold number of total PDP contexts per GPRS session for all GPRS services that
maintains a previously generated alarm condition. If the number of sessions falls beneath the low threshold
within the polling interval, a clear alarm will be generated.
Specifies the low threshold number of total PDP contexts per GPRS session for all GPRS services that
maintains a previously generated alarm condition. If the number of sessions falls beneath the low threshold
within the polling interval, a clear alarm will be generated.
low_thresh
is an integer from 0 and 2000000. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Monitor and set alarms or alerts when the total number of GPRS sessions in the system is equal to or greater
than the set limit.
Alerts or alarms are triggered for GPRS sessions based on the following rules:
than the set limit.
Alerts or alarms are triggered for GPRS sessions based on the following rules:
Enter condition: Actual total number of PDP Contexts is greater than or equal to the high threshold.
Clear condition: Actual total number of PDP contexts is less than the low threshold.
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
threshold poll
command to configure the polling interval and the
threshold monitoring
command to enable thresholding for this value.
Example