Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
Global Configuration Mode Commands (threshold ppp - url-blacklisting)
upgrade limit ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
5695
upgrade limit
Configures upgrade session limits that trigger when the system may execute the software upgrade.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
upgrade limit [ time session_life ] [ usage session_num ]
upgrade
limit
This command issued with no keywords sets all parameters to their defaults.
time
session_life
Default: 120
Defines the maximum number of minutes that a session may exist on the system undergoing a software
upgrade, before it is terminated by the system. As individual user sessions reach this lifetime limit, the system
terminates the individual session(s).
Defines the maximum number of minutes that a session may exist on the system undergoing a software
upgrade, before it is terminated by the system. As individual user sessions reach this lifetime limit, the system
terminates the individual session(s).
session_life
must be an integer ranging from 1 through 1440.
usage
session_num
Default: 100
This keyword defines a low threshold limit of sessions running either on a packet processing card or system-
wide. When a software upgrade is invoked, this parameter applies to the entire system.
When the threshold is crossed (when the number of sessions on the packet processing card or system is less
than this value), the remaining sessions on the card or system are terminated allowing the upgrade to begin.
The remaining sessions on the packet processing card or system are terminated regardless of their session life.
This keyword defines a low threshold limit of sessions running either on a packet processing card or system-
wide. When a software upgrade is invoked, this parameter applies to the entire system.
When the threshold is crossed (when the number of sessions on the packet processing card or system is less
than this value), the remaining sessions on the card or system are terminated allowing the upgrade to begin.
The remaining sessions on the packet processing card or system are terminated regardless of their session life.
session_num
must be an integer from 0 through 6000.
Usage
Use this command to configure upgrade session limits that trigger the system to begin executing the software
upgrade.
upgrade.
Important:
This command is not supported on all platforms.
Important:
Software Patch Upgrades are not supported in this release.