Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
HA Service Configuration Mode Commands
bind ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
5899
bind
Binds the HA service to a logical IP interface serving as the Pi interface and specifies the maximum number of
subscribers that can access this service over the interface.
subscribers that can access this service over the interface.
Product
HA
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > HA Service Configuration
configure > context context_name > ha-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ha-service)#
Syntax
bind address address|range_address ip_mask | range_address/bitmask [ max-subscribers
count ]
count ]
no bind address
address
Specifies the IP address (address) of the interface configured as the Pi interface.
address
is specified in IPv4
dotted-decimal notation.
range_address ip_mask | range_address/bitmask
Specifies the pool of IP addresses (IPv4) of the interface configured as the Pi interface with an enterprise HA
(EHA).
(EHA).
ip_mask
and
bit_mask
specify the number of subnet bits, representing the subnet mask in CIDR
notation and must be a value between 1 to 32.
range_address
is a preconfigured range of IPv4 addresses in Loopback Interface Configuration Mdoe to
enable the Enterprise HA support with enhanced capacity and configured
max-subscribers
count
Default:
2500000
Specifies the maximum number of subscribers that can access this service on this interface.
count
can be configured to an integer from 0 through 4000000.
Important:
The maximum number of subscribers supported is dependant on the license key installed and the
number of active packet processing cards installed in the system.