Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
HA Service Configuration Mode Commands
optimize tunnel-reassembly ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
5919
optimize tunnel-reassembly
Designates that tunnel reassembly optimization will be used for fragmented large packets passed between HA and FA.
Default is disabled.
Default is disabled.
Product
HA
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > HA Service Configuration
configure > context context_name > ha-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ha-service)#
Syntax
[ default | no ] optimize tunnel-reassembly
Usage
Enabling this functionality fragments large packets prior to encapsulation for easier processing.
Tunnel reassembly optimization is disabled by default.
Tunnel reassembly optimization is disabled by default.
Important:
You should not use this command without first consulting Cisco Systems Technical Support. This
command applies to very specific scenarios where packet reassembly is not supported at the far end of the tunnel. There
are cases where the destination network may either discard the data, or be unable to reassemble the packets.
are cases where the destination network may either discard the data, or be unable to reassemble the packets.
Important:
This functionality works best when the HA service is communicating with an FA service running in
a system. However, an HA service running in the system communicating with an FA from a different manufacturer will
operate correctly even if this parameter is enabled.
operate correctly even if this parameter is enabled.
Use the
no
version of this command to disable tunnel optimization if enabled.
Example
The following command enables tunnel reassembly optimization:
optimize tunnel-reassembly