Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
ACS Port Map Configuration Mode Commands
▀ port
▄ Cisco ASR 5x00 Command Line Interface Reference
600
port
Adds or removes an individual or a range of TCP/UDP port numbers associated with an application or protocol from the
current port map.
current port map.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > ACS Port Map Configuration
active-charging service service_name > port-map port_map_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-port-map)#
Syntax
[ no ] port { port_number | range start_port_number to end_port_number }
no
If added previously, removes the specified TCP/UDP port numbers from the current port map.
port_number
Specifies a TCP/UDP port number to add to the current port map.
port_number
is expressed an integer from 1 through 65535.
range start_port_number to end_port_number
Specifies a range of port numbers to add to the current port map.
start_port_number
specifies the starting port number of the range, it must be an integer from 1 through
65535, and must be less than
end_port_number
.
end_port_number
specifies the ending port number of the range, it must be an integer from 1 through
65535, and must be greater than
start_port_number
.
Usage
Use this command to add an individual or a range of TCP/UDP port numbers to a port map. Up to 10 sets of
ports can be configured in each port map.
ports can be configured in each port map.
Example
The following command adds all TCP/UDP port numbers from
3112
through
5000
to the port map:
port range 3112 to 5000